Lantronix EDS-MD Series - Page 119

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 119
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
show status
Displays tunnel connect status.
start character <control>
Sets the connect mode start character. The
character may be input as text, control, decimal, or
hex. A control character has the form <control>C. A
decimal value character has the form \99. A hex
value character has the form 0xFF.
write
Stores the current configuration in permanent
memory.
connect (tunnel-connect:1) level commands
block network disable
Forwards (tunnels) network data in connect mode
tunneling.
block network enable
Discards all data coming in from the connect mode
tunnel before forwarding it to the serial interface
(generally used for debugging).
block serial disable
Forwards (tunnels) serial data in connect mode
tunneling.
block serial enable
Discards all data coming in from the serial interface
before forwarding it to the connect mode tunnel
(generally used for debugging).
clrscrn
Clears the screen.
connect mode always
Enables the tunneling server to always establish
tunneling connections.
connect mode any character
Enables the tunneling server to establish a tunneling
connection when a character is received on the
corresponding line (serial port).
connect mode disable
Disables connect mode tunneling.
connect mode modem control asserted
Enables the tunneling server to make tunneling
connections when the modem control pin is
asserted.
connect mode modem emulation
Enables modem emulation for connect mode
tunneling.
connect mode start character
Enables connect mode tunneling when the
configured start character is received on the line.
default connect mode
Restores the default connect mode as "disable".
default host mode
Connects to the first host in the list that accepts the
connection.
default local port
Uses a random port number as the local port for
establishing tunneling connections to other devices.
default reconnect time
Restores the default reconnect time value for
connect mode tunneling.
default start character
Defaults the connect mode start character.
email connect <number>
Sets an email profile to use to send an email alert
upon establishing a connect mode tunnel.
<number> = the number of the email profile to use.
email disconnect <number>
Sets an email profile to use to send an email alert
upon closing a connect mode tunnel. <number> =
the number of the email profile to use.
exit
Returns to the tunnel level.