Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 121
host <text>
Sets the Hostname or IP address of Mach 10.
mqtt host <text>
Sets the Hostname or IP address of MQTT server.
mqtt port <number>
Sets the Port of MQTT server.
mqtt security disable
Disables SSL for MQTT.
mqtt security enable
Enables SSL for MQTT.
mqtt state disable
Disables MQTT.
mqtt state enable
Enables MQTT.
no proxy host
Restores the Hostname or IP address of the proxy
server.
no proxy password
Restores the password for proxy server.
no proxy username
Clears the user name for the proxy server.
port <number>
Sets the Port of Mach 10.
proxy host <text>
Sets the Hostname or IP address of the proxy
server.
proxy password <text>
Sets the password the proxy server.
proxy port <number>
Sets the Port of the proxy server.
proxy type socks5
Sets the Proxy server type to SOCKS5
proxy username <text>
Sets the user name for the proxy server.
secure port disable
Disables https for Mach10 client.
secure port enable
Enables https for Mach10 client.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
use proxy disable
Disables use of proxy server for this connection.
use proxy enable
Enables use of proxy server for this connection.
validate certificates disable
Disables certificate validation for Mach10 client.
validate certificates enable
Enables certificate validation for Mach10 client.
write
Stores the current configuration in permanent
memory.
connection 1 (config-action-http_post-connection:eth2 link state change:1) level commands
clrscrn
Clears the screen.
default port
Sets default Port number.
default protocol
Sets default HTTP Protocol.
exit
Exits to the next higher level.
host <text>
Sets HTTP server IP address or hostname to be
connected to.
no host
Clears HTTP server IP address or hostname.
no password
Clears the Password.
no url
Clears HTTP request URL.
no username
Clears the Username.
password <text>
Sets the Password used to logon to HTTP server.
port <number>
Sets the Port number which HTTP server is listening
to.
protocol http
Selects HTTP Protocol.
protocol https
Selects HTTPS Protocol.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.