Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 140
dns (dns) level commands
clrscrn
Clears the screen.
exit
Exits to the enable level.
lookup <host_or_ip>
Return a lookup on the DNS name or IP address.
show
Show DNS status.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
email (config-action-email:eth2 link state change) level commands
alarm email email <number>
Specifies the email number to send when the alarm
turns on.
alarm email none
Specifies no email when the alarm turns on.
alarm message <text>
Sets the email message to be sent when the alarm
turns on.
alarm reminder interval <minutes>
Sets the time interval that messages will be sent
while the alarm remains on.
clrscrn
Clears the screen.
default alarm email
Specifies no email when the alarm turns on.
default normal email
Specifies no email when the alarm turns off.
exit
Exits to the next higher level.
no alarm message
Removes the alarm email message.
no alarm reminder interval
Only one message will be sent when the alarm turns
on.
no normal message
Removes the normal email message.
no normal reminder interval
Only one message will be sent when the alarm turns
off.
normal email email <number>
Specifies the email number to send when the alarm
turns off.
normal email none
Specifies no email when the alarm turns off.
normal message <text>
Sets the email message to be sent when the alarm
turns off.
normal reminder interval <minutes>
Sets the time interval that messages will be sent
while the alarm remains off.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
email (config-action-email:eth1 link state change) level commands
alarm email email <number>
Specifies the email number to send when the alarm
turns on.
alarm email none
Specifies no email when the alarm turns on.
alarm message <text>
Sets the email message to be sent when the alarm
turns on.
alarm reminder interval <minutes>
Sets the time interval that messages will be sent
while the alarm remains on.
clrscrn
Clears the screen.