Lantronix EDS-MD Series - Page 366

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 366
credentials <text>
Selects the RSA/DSA certificates by name for the
SSL client.
default protocol
Restores the default protocol as "TCP".
default tcp keep alive idle time
Defaults the TCP keep alive idle time.
default tcp keep alive interval
Restores the default 45 second connect mode TCP
keep alive timeout.
default tcp keep alive probes
Defaults the TCP keep alive probes.
exit
Exits to the next higher level.
initial send binary <binary>
Sets the host connect tunnel Initial Send text
allowing for binary characters. <binary> = string in
binary format that will be sent out the network upon
connection. Within [] use binary decimal up to 255
or hex up to 0xFF.
initial send set <text>
Sets the host connect tunnel Initial Send text. <text>
= ascii string that will be sent out the network upon
connection.
no address
Removes the remote host address used to establish
tunneling connections.
no aes decrypt key
Removes the connect tunnel AES decrypt key.
no aes encrypt key
Removes the connect tunnel AES encrypt key.
no credentials
Clears the RSA/DSA certificate selection.
no initial send
Removes the host connect tunnel Initial Send string.
no port
Removes the remote port used to establish tunnel
connections.
no ssh username
Removes the SSH user name.
no tcp user timeout
Restores the default.
port <number>
Sets the remote port to use for connect mode
tunneling. <number> = number of the port to use.
protocol ssh
Uses SSH protocol for connect mode tunneling.
protocol ssl
Uses SSL protocol for connect mode tunneling.
protocol tcp
Uses TCP protocol for connect mode tunneling.
protocol tcp aes
Uses TCP protocol with AES encryption for connect
mode tunneling.
protocol telnet
Uses Telnet protocol (with IAC) for connect mode
tunneling.
protocol udp
Uses UDP protocol for connect mode tunneling.
protocol udp aes
Uses UDP protocol with AES encryption for connect
mode tunneling.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
show statistics
show connection statistics
ssh username <text>
Sets the SSH user name for use when establishing
tunneling connections with other devices. <text> =
SSH user name.
tcp keep alive idle time <milliseconds>
Sets the TCP keep alive idle time. This is the initial
keep alive timeout. <milliseconds> = timer value, in
milliseconds.
tcp keep alive interval <milliseconds>
Enables TCP keep alive for connect mode tunneling
and sets the timer. <milliseconds> = timer value, in
milliseconds.