Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 55
block network enable
Discards all data coming in from the accept mode
tunnel before forwarding it to the serial interface
(generally used for debugging).
block serial disable
Forwards (tunnels) serial data in accept mode
tunneling.
block serial enable
Discards all data coming in from the serial interface
before forwarding it to the accept mode tunnel
(generally used for debugging).
clrscrn
Clears the screen.
credentials <text>
Selects the RSA/DSA certificates by name for the
SSL server.
default accept mode
Restores the default accept mode as "always".
default local port
Uses the default port number as the local port for
accept mode tunneling. The default port is 10000 +
#, where # is the line number for this tunnel.
default protocol
Restores the default protocol as "TCP".
default start character
Defaults the accept mode start character.
default tcp keep alive idle time
Defaults the TCP keep alive idle time.
default tcp keep alive interval
Restores the default 45 second accept mode TCP
keep alive timeout.
default tcp keep alive probes
Defaults the TCP keep alive probes.
email connect <number>
Sets an email profile to use to send an email alert
upon establishing an accept mode tunnel.
<number> = the number of the email profile to use.
email disconnect <number>
Sets an email profile to use to send an email alert
upon closing an accept mode tunnel. <number> =
the number of the email profile to use.
exit
Returns to the tunnel level.
flush serial disable
Characters already in the serial data buffer are
retained upon establishing an accept mode
tunneling connection.
flush serial enable
Flushes the serial data buffer upon establishing an
accept mode tunneling connection.
flush start character disable
Enables forwarding of the accept start character into
the network.
flush start character enable
Disables forwarding of the accept start character
into the network.
initial send binary <binary>
Sets the accept tunnel Initial Send text allowing for
binary characters. <binary> = string in binary format
that will be sent out the network upon connection.
Within [] use binary decimal up to 255 or hex up to
0xFF.
initial send set <text>
Sets the accept tunnel Initial Send text. <text> =
ascii string that will be sent out the network upon
connection.
kill connection
Disconnects the active accept mode tunneling
connection.
local port <number>
Sets the port to use for accept mode tunneling.
<number> = number of the port to use.
no aes decrypt key
Removes the accept tunnel AES decrypt key.
no aes encrypt key
Removes the accept tunnel AES encrypt key.