Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 676
echo pluses enable
Echoes the +++ characters when entering modem
command mode.
error unknown commands disable
Returns OK on unknown AT commands.
error unknown commands enable
Returns an error upon unknown AT commands.
exit
Returns to the tunnel level.
incoming connection automatic
Automatically answer incoming network
connections.
incoming connection disabled
Disable incoming network connections.
incoming connection manual
Wait for an ATA command before answering an
incoming network connection.
no connect string
Removes optional CONNECT string information for
modem emulation.
reassert
Asserts tunnel modem status with current
configured values.
response type numeric
Uses numeric type responses.
response type text
Uses text type responses.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
show status
Displays tunnel modem status.
verbose response disable
Does not send Modem Response Codes.
verbose response enable
Sends Modem Response Codes out on the Serial
Line.
write
Stores the current configuration in permanent
memory.
ntp (config-clock-ntp) level commands
clrscrn
Clears the screen.
default server
Restores the default NTP server address.
exit
Exits to the next higher level.
server <text>
Sets the NTP server address.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
packing (tunnel-packing:16) level commands
clrscrn
Clears the screen.
default packing mode
Sets to default packing mode, which is "Disable"
default send character
Removes the send character for packing mode.
default threshold
Restores the default threshold.
default timeout
Restores the default packing mode timeout.
exit
Returns to the tunnel level.
no trailing character
Removes the trailing character for packing mode.
packing mode disable
Disables packing. Data is sent to the network when
received.
packing mode send character
Sets packing mode to accumulate data and transmit
it upon receiving the configured send character on
the line (serial port).