Lantronix EDS-MD Series - Page 683

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 683
threshold <bytes>
Sets the threshold (byte count). If the queued data
reaches this threshold then the data will be sent.
<bytes> = number of bytes in the threshold.
timeout <milliseconds>
Sets the timeout value for packing mode in
milliseconds. <milliseconds> = timeout value, in
milliseconds.
trailing character <control>
Sets the trailing character for packing mode. The
character may be input as text, control, decimal, or
hex. A control character has the form <control>C. A
decimal value character has the form \99. A hex
value character has the form 0xFF.
write
Stores the current configuration in permanent
memory.
packing (tunnel-packing:7) level commands
clrscrn
Clears the screen.
default packing mode
Sets to default packing mode, which is "Disable"
default send character
Removes the send character for packing mode.
default threshold
Restores the default threshold.
default timeout
Restores the default packing mode timeout.
exit
Returns to the tunnel level.
no trailing character
Removes the trailing character for packing mode.
packing mode disable
Disables packing. Data is sent to the network when
received.
packing mode send character
Sets packing mode to accumulate data and transmit
it upon receiving the configured send character on
the line (serial port).
packing mode timeout
Sets packing mode to accumulate data and transmit
it after a specified amount of time (timeout).
send character <control>
Sets the send character for packing mode. The
character may be input as text, control, decimal, or
hex. A control character has the form <control>C. A
decimal value character has the form \99. A hex
value character has the form 0xFF.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
threshold <bytes>
Sets the threshold (byte count). If the queued data
reaches this threshold then the data will be sent.
<bytes> = number of bytes in the threshold.
timeout <milliseconds>
Sets the timeout value for packing mode in
milliseconds. <milliseconds> = timeout value, in
milliseconds.
trailing character <control>
Sets the trailing character for packing mode. The
character may be input as text, control, decimal, or
hex. A control character has the form <control>C. A
decimal value character has the form \99. A hex
value character has the form 0xFF.
write
Stores the current configuration in permanent
memory.
packing (tunnel-packing:6) level commands
clrscrn
Clears the screen.