Lantronix EDS-MD Series

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 693
no password
Removes the password so connections will be
accepted unchallenged.
password <text>
Sets the password required on the network side of
the tunnel to begin a connection.
prompt disable
Inhibits any prompting for password on the network
side of the tunnel.
prompt enable
Sets up so a user on the network side of the tunnel
will be prompted for a password.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
password (tunnel-accept-password:1) level commands
clrscrn
Clears the screen.
exit
Exits to the next higher level.
no password
Removes the password so connections will be
accepted unchallenged.
password <text>
Sets the password required on the network side of
the tunnel to begin a connection.
prompt disable
Inhibits any prompting for password on the network
side of the tunnel.
prompt enable
Sets up so a user on the network side of the tunnel
will be prompted for a password.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
write
Stores the current configuration in permanent
memory.
port forwarding rule 1 (config-portforwarding:1) level commands
clrscrn
Clears the screen.
default protocol
Restores the default value of the protocol (Both).
exit
Exits to the config-gateway level.
friendly name <text>
Set the friendly name for port forwarding rule <text>
= friendly name
ingress ip address <IP address>
Sets the original WAN destination IP address for
port forwarding rule.
ip address <IP address>
Sets the LAN destination IP address for port
forwarding rule.
no friendly name
Remove the friendly name.
no ingress ip address
Clears the original WAN destination IP address for
port forwarding rule.
no ip address
Clears the LAN destination IP address for port
forwarding rule.
no port or range
Clears the WAN port or range for port forwarding
rule.
no target port
Clears the LAN destination port for port forwarding
rule.
port forwarding rule <number>
Change to config gateway port forwarding level.