5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 711
Clears the gateway for static route network.
Clears the route interface. The WAN interface is
used if no interface is specified.
Clears the IP address for static route network.
Displays the current configuration.
Displays the last 20 commands entered during the
current CLI session.
Disables the static route.
Enables the static route.
Change to config gateway static route level.
Stores the current configuration in permanent
memory.
static route 4 (config-staticroute:4) level commands
Restores the metric to default value.
Exits to the config-gateway level.
Set the friendly name for static route. <text> =
friendly name
Sets the gateway for static route network.
Sets the route interface <text> = interface name
Sets the metric for static route. <number> = metric
Sets the IP address and network mask for static
route network.
Clears the gateway for static route network.
Clears the route interface. The WAN interface is
used if no interface is specified.
Clears the IP address for static route network.
Displays the current configuration.
Displays the last 20 commands entered during the
current CLI session.
Disables the static route.
Enables the static route.
Change to config gateway static route level.
Stores the current configuration in permanent
memory.
static route 5 (config-staticroute:5) level commands
Restores the metric to default value.
Exits to the config-gateway level.
Set the friendly name for static route. <text> =
friendly name
Sets the gateway for static route network.
Sets the route interface <text> = interface name
Sets the metric for static route. <number> = metric
Sets the IP address and network mask for static
route network.