Lantronix EDS-MD Series - Page 727

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 727
exit
Exits to the configuration level.
exit connect menu disable
On the login connect menu, removes the menu item
allowing the user to exit to the CLI.
exit connect menu enable
On the login connect menu, inserts the menu item
allowing the user to exit to the CLI.
line <line>
Enters the line level. <line> = number of the line
(serial port) to be configured.
login connect menu disable
Disables the login connect menu, so a user will get
the CLI immediately after logging in.
login connect menu enable
Enables the login connect menu, so a user will get
the menu rather than the CLI immediately after
logging in.
no send break
Removes the configured send break character.
preview connect menu
Shows the layout of the connect menu with current
settings.
send break <control>
Sets the optional send break character. <text> = the
character. The character may be input as text,
control, decimal, or hex. A control character has the
form <control>C. A decimal value character has the
form \99. A hex value character has the form 0xFF.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
terminal <line>
Enters the configure-terminal level. <line> = number
of the terminal line (serial port) to be configured.
terminal network
Enters the configure-terminal level for the network.
terminal type <text>
Sets the terminal type.
tunnel <line>
Enters the tunnel level. <line> = number of the
tunnel line (serial port) to be configured.
write
Stores the current configuration in permanent
memory.
terminal 16 (config-terminal:16) level commands
break duration <milliseconds>
Sets how long a break should last when it is being
sent to the line. <milliseconds> = number of
milliseconds.
clrscrn
Clears the screen.
default break duration
Restores the break duration to the default value
(500 ms).
default terminal type
Sets the default terminal type, "UNKNOWN".
echo disable
Disables echoing of characters received on the line
back to the line.
echo enable
Enables echoing of characters received on the line
back to the line.
exit
Exits to the configuration level.
exit connect menu disable
On the login connect menu, removes the menu item
allowing the user to exit to the CLI.
exit connect menu enable
On the login connect menu, inserts the menu item
allowing the user to exit to the CLI.
line <line>
Enters the line level. <line> = number of the line
(serial port) to be configured.