Lantronix EDS-MD Series - XML Settings and Export Configuration; XML Settings Overview; XML Export Configuration

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 91
default tcp keep alive interval
Restores the default 45 second accept mode TCP
keep alive timeout.
default tcp keep alive probes
Defaults the TCP keep alive probes.
email connect <number>
Sets an email profile to use to send an email alert
upon establishing an accept mode tunnel.
<number> = the number of the email profile to use.
email disconnect <number>
Sets an email profile to use to send an email alert
upon closing an accept mode tunnel. <number> =
the number of the email profile to use.
exit
Returns to the tunnel level.
flush serial disable
Characters already in the serial data buffer are
retained upon establishing an accept mode
tunneling connection.
flush serial enable
Flushes the serial data buffer upon establishing an
accept mode tunneling connection.
flush start character disable
Enables forwarding of the accept start character into
the network.
flush start character enable
Disables forwarding of the accept start character
into the network.
initial send binary <binary>
Sets the accept tunnel Initial Send text allowing for
binary characters. <binary> = string in binary format
that will be sent out the network upon connection.
Within [] use binary decimal up to 255 or hex up to
0xFF.
initial send set <text>
Sets the accept tunnel Initial Send text. <text> =
ascii string that will be sent out the network upon
connection.
kill connection
Disconnects the active accept mode tunneling
connection.
local port <number>
Sets the port to use for accept mode tunneling.
<number> = number of the port to use.
no aes decrypt key
Removes the accept tunnel AES decrypt key.
no aes encrypt key
Removes the accept tunnel AES encrypt key.
no credentials
Clears the RSA/DSA certificate selection.
no email connect
Discontinues sending email alerts upon establishing
an accept mode tunnel.
no email disconnect
Discontinues sending email alerts upon closing an
accept mode tunnel.
no initial send
Removes the accept tunnel Initial Send string.
password
Enters the next lower level.
protocol ssh
Uses SSH protocol for accept mode tunneling.
protocol ssl
Uses SSL protocol for accept mode tunneling.
protocol tcp
Uses TCP protocol for accept mode tunneling.
protocol tcp aes
Uses TCP protocol with AES encryption for accept
mode tunneling.
protocol telnet
Uses Telnet protocol (with IAC) for accept mode
tunneling.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
show status
Displays tunnel accept status.