EDS1100/2100 Command Reference 6
1: About This Guide
This guide describes how to configure the EDS1100 and EDS2100 using the Command Line
Interface (CLI) and/or Extensible Markup Language (XML). It is written for software developers
and system integrators.
Chapter Summaries
This table lists and summarizes each chapter and appendix.
Conventions
The table below lists and describes the conventions used in this book.
Chapter Summary
Chapter 2: Overview
Gives an overview of CLI and XML.
Chapter 3: Command Line Interface
Lists commands and describes how to use CLI to
configure the EDS1100 and EDS2100.
Chapter 4: Configuration Using XML
Lists XCR groups and items and describes how to use
XCRs to configure the EDS1100 and EDS2100.
Chapter 5: Commands and Levels
Provides an index of the CLI Command Hierarchy with
hyperlinks to the corresponding command details.
Convention Description
Bold text Default parameters.
Italic text Required values for parameters
Brackets [ ] Optional parameters.
Angle Brackets < > Possible values for parameters.
Pipe | Choice of parameters.
Warning Warning: Means that you are in a situation that could cause
equipment damage or bodily injury. Before you work on any
equipment, you must be aware of the hazards involved with electrical
circuitry and familiar with standard practices for preventing
accidents.
Note Note: Means take notice. Notes contain helpful suggestions, information,
or references to material not covered in the publication.
Caution Caution: Means you might do something that could result in faulty
equipment operation, or loss of data.
Screen Font
(Courier New)
CLI terminal sessions and examples of CLI input.
To Next Page
Loading...
Need help?
General