4: Quick Setup
SLC™ Console Manager User Guide 38
After you complete the Quick Setup script, the changes take effect immediately as shown in
Figure 4-7.
Subnet Mask The subnet mask specifies the network segment on which the SLC console
manager resides. There is no default. If you selected DHCP or BOOTP, this
prompt does not display.
Default Gateway IP address of the router for this network. There is no default.
Hostname The default host name is slcXXXX, where XXXX is the last 4 characters of the
hardware address of Ethernet Port 1. There is a 64-character limit (contiguous
characters, no spaces).
Note: The host name becomes the prompt in the command line interface.
Domain If desired, specify a domain name (for example, support.lantronix.com). The
domain name is used for host name resolution within the SLC console manager.
For example, if abcd is specified for the SMTP server, and mydomain.com is
specified for the domain, if abcd cannot be resolved, the SLC device attempts to
resolve abcd.mydomain.com for the SMTP server.
Time Zone If the time zone displayed is incorrect, enter the correct time zone and press Enter.
If the entry is not a valid time zone, the system guides you through selecting a time
zone. A list of valid regions and countries displays. At the prompts, enter the
correct region and country.
Date/Time If the date and time displayed are correct, type n and continue. If the date and time
are incorrect, type y and enter the correct date and time in the formats shown at
the prompts.
Sysadmin
password
Enter a new sysadmin password.
To Next Page
Loading...
Need help?
General