Lantronix Spider

11: Command Reference
Spider™ and SpiderDuo® KVM-over-IP Device User Guide 109
Parameters
dns1 <IP Address>
dns2 <IP Address>
gateway <IP Address>
hostname <Host Name>
ipaddr <IP Address>
ipv6 <enable/disable>
ipv6addr <IPv6 Address/Prefix>
mask <Mask>
state <dhcp|bootp|static>
Note: To clear IPV4 addresses, set ipv4 address to “0.0.0.0”.To clear IPV6 address,
set ipv6 address to “::” or “::/128”.
set network misc
Syntax
set network misc <parameters>
Parameters
bwlimit <8-10000 kbit/s>
httpsports <TCP Port>
httpport <TCP Port>
proxy <enable/disable>
proxyhost <IP Address>
proxyport <TCP Port>
telnet <enable/disable>
telnetport <TCP Port>
setupprotocol<enable/disable>
ssh <enable/disable>
sshport <TCP Port>
Description
Sets miscellaneous network parameters.
set network interface
set network interface <parameters>
Parameters
mode <auto|10mbit-half|100mbit-half|10mbit-full|100mbit-full>
Description
Sets network interface modes.
show network all
Syntax
show network all
Description
Displays all network settings.