10
LARIUS 2 - painting
English
H9
H7
H8
H10
I3
I
ROUTINE MAINTENANCE
• Check that all the hose connections are tight.
• Clean and, if necessary, replace the worn seals.
• Check filters (I1), (I2) and (I3) and replace them when ne-
cessary.
• Check the nozzle on the spray gun and clean it.
• With the spray gun over the thinner tank, press the trigger
in order to let the thinner circulate during at least five minu-
tes.
• If necessary change the thinner and repeat this operation
more times until all the residues of the product will have been
eliminated.
• Clean the product hose (H7) by means of a rag and wash
the filters (H8), (H9) and (H10) with the solvent.
• After the use of products with a base of polyvinyl alcohol or
of water soluble products, first clean the pump with water
and then let some alcohol circulate through the plant.
If it is foreseen a long period of standstill for
the pump, after the cleaninng let some light
mineral oil circulate in order to protect it against
corrosion.
I2
I1
To Next Page
Loading...