Laser BLU-BD2000 - Page 30

28
Troubleshooting
Loose or damaged
component video cables
If using component output, check that the three
cables are all properly plugged in and not
damaged. Make sure the colour of the plugs
match the jacks on both ends.
Incorrect video output port If using composite video output, check that the
cable is not incorrectly plugged into a c omponent
video jack.
Incorrect
colour
Incorrect colour space
seng
If using HDMI for video output, check the colour
space seng on the TV and player.
Picture rolling
or
split picture
Video system is not
supported by the TV
Set the correct TV System in the Setup Menu.
“No Disc” or
“Unknown
No disc or incompable
disc loaded in player
Eject disc and check. Verify player funconality
by inserng a known working disc.
Disc” Error Dirty disc recording surface Eject the disc and clean any dirt or fingerprints.
Disc not properly loaded Eject disc and make sure the label side is facing
up and the record side is facing down.
Condensaon on the Laser
pick-up head
Turn on the player, eject the disc and leave the
player on for about an hour.
Remote
control
failure
Remote control is out of
range
Use the remote control within the effecve
range.
Point Remote at IR receiver on front Panel.
Low baery Replace the baeries.
Temporary
funcon
Scratched or damaged disc
is used
Replace the disc.
failure Some funcons are not
available during playback
Stop playback completely, then try again.
Interference from other
devices
Idenfy interference by turning off other
devices, and then relocate or replace the
offending device.
Some Setup
Menu items
are greyed
out
Some setup opons cannot
be changed while a disc is
playing. Some setup
opons may be mutually
exclusive with other setup
opons.
Fully stop playback by pressing the stop buon
twice, eject the disc and try the Setup Menu
again.
No colour