Laser SB3 User Manual

• Weight will come onto the mast at approx 45 degrees and it will
need to be supported and lowered into the boat.
ips for preparing the Laser SB3 prior to trailing: T
Please note:
This is a guide
• The mast should not overhang beyond the legal limits at the rear.
to assist you in preparing your boat for trailing; it is not a guide
the legal restrictions and laws covering the towing your boat. It is the
• Remove chocks or raise trailer supports before towing
e standing
•
• o the trailer, put the straps under the granny
• towing with the cover on, put the tie down straps on underneath
over.
to
responsibility of the persons towing to ensure that they comply with the legal
requirements for the countries which the trailer will be utilised.
• When securing the mast to the mast supports keep the spreaders
facing down and ensure that there is enough slack in th
rigging to enable the mast to sit on the rear support without putting
strain on the spreaders.
Ensure that everything is secure in the boat.
When securing the boat t
rails and not over the top of them.
• Do not tow with the keel in the raised position or it will swing and cause
damage to the keel and hull.
• Secure the keel fore and aft to stop it moving in the event of a sudden
stop.
• Pack the keel box to stop the keel moving during transit.
When
the cover and the strong back mast support on top of the c

Laser SB3 Specifications

General

Brand	Laser
Model	SB3
Category	Boat
Language	English