2.4 Safety Label
Please take the following measures when there is open fire during engraving (LX1 is capable of detecting
high temperature. The machine will cease operation when the temperature reaches 50°C).
1.Cut off the power supply
2.Douse the flames with fire extinguisher
Inhale smoke and particulate matter
1.Fumes and particulates that can irritate the respiratory system may be generated when engraving or
cutting certain materials. It is recommend to use the product with an air purifier or in a well-ventilated
place. Please wear a protective mask if necessary.
2.If respiratory irritation or similar symptoms occur, immediately move the patient to a site with fresh air
and seek medical help.
2.3.4 Emergency Response
Label Warning Position
Be careful of pinch point.
Do NOT touch or block
the moving parts when in operation.
On the back of
the laser module
On the X axis
On the X axis
Be careful of hot surfaces. Do NOT touch
the laser module while its working or when
the machine has not yet cooled down after working.
Do NOT unplug or plug the
connection cable of laser and
artist module with power on.
Do NOT leave the machine
unattended during operation.
Be careful of fire.
On the laser module
The laser class of laser product is Class 4.
Please avoid eye or skin exposure to
direct or scattered laser light.
On the laser module
The laser class of laser product is Class 1.
Please avoid eye or skin exposure to direct
or scattered laser light when the opening
and closing of the protection cover are not
linked to the laser emission.
On the top of the
protection cover
04
To Next Page
Loading...