LaserPro C 180 I - Chapter 4. Troubleshooting; Section 1. Error Messages

Chapter 4. Troubleshooting
Section 1. Error messages
Error Message What does it mean? What to do?
"Laser Tube Error Laser
tube is over heat please
press any key to stop."
This means that the laser
tube’s temperature is too
high or the laser tube is
dead.
1. Turn off the machine to allow the
laser tube to cool off.
2. Restart the machine to see if the
same message shows.
"HPGL Command Error
Get an odd number of
parameters please press
any key to stop"
This means error has
occurred during the
transfer of data from
driver to firmware.
1. Resend the data file.
"WARNING!
SmartGUARD fire alarm
system is activated, please
reboot machine"
The SmartGuard fire
alarm system has been
activated.
1. Turn off the machine.
2. Check for fire or smoke.
3. Clear any hazards.
4. Turn on the machine.
"WARNING! Emergency
stop is activated, please
free the emergency stop to
continue next job"
The Emergency button has
been pushed down.
1. Release the emergency button by
turning it clockwise.
"Please install the Auto
Focus pin first before
performing the auto
focusing or focus tuning"
User is attempting to use
the Autofocus function
while the Autofocus pin is
not installed.
1. Press “F1” to return previous
menu.
2. Install the autofocus pin and to
perform Autofocus.
3.
" HPGL Command Error
Command: Address:
Please press any key to
stop"
The firmware on the
machine and the driver is
not compatible.
1. Find out the firmware and driver
versions that are being used.
2. Upgrade to the most up-to-date
firmware and driver versions or use
compatible versions.
"Machine Moving Limit
reach upper limit switch
please move opposite
direction"
The Z-platform has
reached the top most limit.
1. Press any key to return the previous
page.
2. Check that the Z-
limit switch sensor
is working properly.
3. Continue work or lower the
Z-platform if necessary.
"PCL Command Error
Command: Address:
Please press any key to
stop"
The firmware on the
machine and the
application driver is not
compatible.
1. Find out the firmware and driver
versions that are being used.
2. Upgrade to the most up-to-date
firmware and driver versions or use
compatible versions.
"Error! Please check the
lens carriage position
under relative mode"
The output object is out of
the working area and
cannot be outputted.
1. Check that the output object can be
outputted on the working area
under the correct position mode.
2. Adjust the pen carriage to an open
area. For e.g Origin point for
relative mode or center of the table
for Center mode.
3. Restart the job.