Need help?Do you have a question about the Lauda MC 250 and is the answer not in the manual?
General| Cooling capacity at 20°C | 0.25 kW |
|---|---|
| Pump capacity pressure | 0.4 bar |
| Pump capacity flow rate | 15 l/min |
| Cooling Capacity | 0.25 kW at 20°C |
| Temperature Stability | ±0.05°C |
| Refrigerant | R134a |
| Power Supply | 230 V, 50/60 Hz |
| Cooling capacity at 0°C | 0.2 kW |
General safety instructions for operating the equipment safely and preventing hazards.
Specifies approved heat transfer liquids and their properties.
Lists required protective clothing, gloves, and goggles.
Details the components of the control panel, including display and buttons.
Explains the function and positions of the mains power switch.
Details the equipment's compliance with EMC standards by region.
Step-by-step guide for filling the device with heat transfer liquid.
Instructions for connecting the device to the mains power supply.
Details how to set the pump pressure using the bypass regulator.
Explains how to reduce or increase pump pressure using the bypass wheel.
Procedure for switching the circulation chiller on.
Instructions for setting the desired operating temperature.
Details how to set upper and lower temperature limits for safety.
Steps to configure the automatic shut-down timer.
Steps to configure the automatic start timer.
Lists commands for sending data to the thermostat.
Lists commands for requesting data from the thermostat.
Lists common error codes and their descriptions.
Procedure for adjusting the temperature sensor offset for accuracy.
Steps to reset the device to its original factory configuration.
Safety precautions to be observed before performing maintenance.
Explains how device faults are displayed and handled.
Procedure for draining the heat transfer liquid from the device.
Guidelines for the safe disposal of refrigerant.
To Next Page
