The current bath temperature (T
int
) is displayed with the status display above
it, the expanded status display at the top margin and the soft-key bar at the
bottom margin.
The pump starts (exception: "Standby" operating status).
When standby is activated ( 7.4.4), the last operating values are taken
over.
With the key T
max
you check or change the overtemperature switch-off
point:
On pressing the key T
max
the value in the upper line is dis-
played.
(Setting the overtemperature switch-off point T
max
( 7.4.1)).
To Next Page
Loading...
