LAUNCH TECH CRT511 - Program Multi-Sensor; TPMS Service; Relearn Procedure

LAUNCHLAUNCH
38 39
www.x431.com +86 755 8455 7891 www.x431.com +86 755 8455 7891
Figure 5-27
Press the
button to return to the previous screen. Press the OK button to
continue programming other sensors.
5.3 TPMS Service
This function includes two modules: Relearn Procedure and Part Number
Lookup.
Select TPMS SERVICE and press the OK button to enter the following screen.
Figure 5-28
5.3.1 Relearn procedure
This function allows you to check and view the detailed TPMS sensor relearn
procedures.
Relearn operation applies only when the newly programmed sensor IDs are
di󰀨erent from the original sensor IDs stored in the vehicle’s ECU. Relearn is
Figure 5-24
After the sensor is successfully programmed, the following screen will appear.
Figure 5-25
Press the
button to return to the previous screen. Press the OK button to
continue programming other sensors.
5.2.4 Program multi-sensor
This function allows users to program multiple sensors simultaneously. Up to 8
sensors can be programmed at the same time.
Stack up multiple sensors, select CREATE MULTI-SENSOR (1-8) to start
programming.
Figure 5-26
After the sensors were successfully programmed, the following screen will
appear.