LAUNCH Tyre Changer(TWC-502RMB)
iii
² Caution should be taken
when separating the tyre
from rim. The bead breaker
shoe will move rapidly and
forcefully when the pedal is
depressed. Keep body and
materials away from the
work area.
² If the clamping cylinder is
open during clamping,
squeezing on hands can be
resulted. Remember to
keep hands away from the
inside of the tyre when
clamping.
² High voltage power!
Dangerous!
² This is where the
compressed air gun is
connected with the air pipe.
Connect the compressed air
gun with the air connector.
² The pressure of the
compressed air should not
exceed 10 bar.
Description of Safety Signs
² To prevent accidents from
occurring, make sure to
keep hands and other body
parts away when fastening
the mount/demount head or
when the turntable is
running.
² Be careful when connecting
and disconnecting air
source. Bleed the air in the
cylinder completely when
maintaining the air pipes to
prevent accidents from
occurring.
² Don’t keep hands or other
body parts between the
clamping jaw and clamping
rim.
² Pay attention to the safety
regulations in the swinging
area of the tilting post to
avoid accidents from
happening.
² Before inflating check if the
clamping rim and the tyre
match each other, and if
they are in good condition.
Any negligence may result
in fatal explosion. Similar
accident may occur if the
inflating air exceeds the
allowed pressure.
To Next Page
Loading...