LAUNCH
CReader Series English User’s Manual
29
Figure 7-2
2. In figure 7-2, type in the Product Serial Number (located at the back of the
tool).
Note: Once the S/N is entered, “Restore System” becomes activated, which is used to
restore system if a new memory card is replaced.
3. Click [Device Upgrade] to enter the sign-up page. Enter the information and
click [Submit] (refer to figure 7-3).
Figure 7-3
(If you need the Register Code, please refer to steps 4~7.)
(If you have the Register Code, directly proceed to step 8.)
4. The Register Code can be found in your tool. Connect one end of the USB
cable to your tool, and the other end on the computer.
To Next Page
Loading...
Need help?
General
