Launch CReader 8011 User Manual

V1.00.001
2017-09-22
Note: This user manual applies to the following CReader models: CReader 6011,
CReader 7001, CReader 7001F, CReader 8001, CReader 8011, CReader 8021 and
CReader 9081. All illustrations and descriptions herein are only for reference. We
reserve the right to make changes due to software update without prior written
notice.

Launch CReader 8011 Specifications

General

Data Stream	Live data stream
Diagnostic Protocols	OBDII/EOBD
Power Supply	Built-in rechargeable battery
Operating Voltage	12V
Operating Temperature	-10°C to 50°C
Storage Temperature	-20°C to 60°C
Memory	2GB RAM
Communication	Bluetooth

Summary

Safety Precautions and Warnings

2. General Information

2.1 On-Board Diagnostics (OBD) II

Explanation of the OBD II system and its purpose in vehicle diagnostics.

2.2 Diagnostic Trouble Codes (DTCs)

Definition and structure of OBD II Diagnostic Trouble Codes (DTCs).

2.4 OBD II Readiness Monitors

2.5 OBD II Monitor Readiness Status

5. Diagnose

5.1 OBDII/EOBD Diagnosing

1. Read Codes

2. Erase Codes

3. I/M Readiness

4. Data Stream

5. View Freeze Frame

5.2 System Diagnosing (Only for CReader 6011/8001/8011/8021)

5.2.1 Read Vehicle Information

5.2.2 Read Fault Code

5.2.3 Clear Fault Code

5.2.4 Read Data Stream

5.3 Resetting (Only applies to CReader 7001/7011F/8001/8011/8021/9081)

5.3.1 Oil Reset Service (Only applies to CReader 7001/7011F/8001/8011/8021/9081)

Resets the engine oil life system to update the oil change interval.

5.3.2 Electronic Parking Brake Reset (Only applies to CReader 7011F/8001/8011/8021/9081)

Resets the electronic parking brake system after brake pad replacement.

5.3.3 Steering Angle Sensor (Only applies to CReader 7011F/8021/9081)

Resets the steering angle sensor after replacement or alignment.

5.3.4 Battery Maintenance System Reset (Only applies to CReader 7011F/8011/8021/9081)

Resets the battery monitoring unit and clears low battery fault information.

5.3.5 Diesel Particulate Filter (DPF) Regeneration (Only applies to CReader 7011F/9081)

Clears Particulate Matter (PM) from the DPF filter to stabilize performance.

5.3.6 Tire Pressure Monitor System Reset (Only applies to CReader 9081)

Resets the tire pressure monitoring system after maintenance or component replacement.

5.3.7 ABS Bleeding (Only applies to CReader 7011F/9081)

Performs bi-directional tests for the Anti-lock Braking System (ABS).

5.3.8 Gear Learning (Only applies to CReader 9081)

Learns crankshaft position sensor data for accurate engine misfire diagnostics.

5.3.9 IMMO Service (Only applies to CReader 9081)

Manages immobilizer system functions, including anti-theft key matching.

5.3.10 Injector Coding (Only applies to CReader 9081)

Writes or rewrites injector codes for accurate cylinder injection quantity control.

5.3.11 Electronic Throttle Position Reset (Only applies to CReader 9081)

Resets throttle actuators to default state for accurate air intake control.

7. Register & Update

Method 1: Via Memory Card (recommended)

Method 2: Via USB Cable