INSTRUCTIONS MANUAL
-10-
30
Æ ENTER Æ
Type in the vacuum time or confirm the previous value. To simply confirm, press ENTER. To
type in, use keys 0 to 9.
Æ 2 Æ 0 Æ
After vacuum time has been confirmed, the “Automatic Oil” message will flash. To confirm,
press ENTER
Æ ENTER Æ
If “Automatic Oil” is confirmed, when the vacuum operation is completed the system will
automatically reintegrate with the same quantity of oil extracted during recovery.
Æ ENTER Æ
In order to reintegrate a quantity of oil different from that discharged following recovery, set as
follows. After confirmation of the vacuum time, “Automatic Oil” will begin to flash. Press the
down arrow (↓) key to move to “Oil xx cc,” then use the keys 0 to 9 to type the volume of oil to
be automatically reintegrated after vacuum, and press ENTER
Æ ↓ Æ
Æ ENTER Æ
After “AUTOMATIC OIL” or the quantity of oil to be reintegrated has been confirmed, “Charging
xxxx g” will begin to flash.
Set the quantity of fluid to be reintegrated as follows:
<AUTOMATIC PROCEDURE>
ASSISTED PROCEDURE
NEXT MENU
Gas avail xxxxx g
VACUUM xx min
AUTOMATIC OIL
OIL xx CC
FILLING xxxx g
<VACUUM xx min>
AUTOMATIC OIL
OIL xx CC
FILLING xxxx g
<VACUUM 20 min>
AUTOMATIC OIL
OIL xx CC
FILLING xxxx g
<VACUUM 20 min>
AUTOMATIC OIL
OIL xx CC
FILLING xxxx g
VACUUM 20 min
<AUTOMATIC OIL>
OIL xx CC
FILLING xxxx g
VACUUM 20 min
<AUTOMATIC OIL>
OIL xx CC
FILLING xxxx g
VACUUM 20 min
AUTOMATIC OIL
<FILLING xxxx g>
VACUUM 20 min
<AUTOMATIC OIL
>
OIL xx CC
FILLING xxxx g
VACUUM 20 min
AUTOMATIC OIL
<OIL xx CC>
FILLING xxxx g
VACUUM 20 min
AUTOMATIC OIL
<OIL 30 CC>
FILLING xxxx g
VACUUM 20 min
OIL 30 CC
<FILLING xxxx g
>
To Next Page
Loading...
Need help?
General