INSTRUCTIONS MANUAL
-11-
1. MANUAL OPERATION: set the quantity of refrigerant in grams for the A/C system to be
charged. For example, for 850g press key 8, key 5 and key 0, “Charging 850 g”. After
setting the quantity, confirm by pressing the ENTER key.
On most systems, the quantity of fluid to be reintegrated is given on the plate inside the
engine compartment of the vehicle. If you do not know the correct quantity, consult the
relevant manuals.
2. The DATABASE BASIC may be used if installed. Press the ↓ key. The following will
appear on the display
Find the relevant vehicle code on the “table” provided. Use the numerical keypad to
enter the code. Then press the ENTER key to confirm. The following will appear on
the display:
where “wxyz” refers to the grams of refrigerant for the vehicle selected. The machine is
now ready to enter the correct quantity of refrigerant. Confirm by pressing the ENTER
key. Please contact your retailer if you wish to install the DATABASE BASIC (DBB).
3. The DATABASE ADVANCED (DBA) may be used if installed: Press the key, the
following will appear on the display
Use the arrow keys (↓↑) to select the required vehicle brand and press ENTER to confirm. The
display will now show the various models (for example, if the brand chosen was FORD): *
Use the arrow keys (↓↑) to select the model required and press ENTER to confirm. The
following will appear on the display: *
<COUGAR>
ESCORT
ESCORT D
FIESTA
<ALFA ROMEO>
AUDI
BMW
CHRYSLER/JEEP
VACUUM 20 min
OIL 30 CC
<FILLING wxyz g
>
INSERT CODE
CAR MODEL
000
Press ENTER to quit
VACUUM 20 min
AUTOMATIC OIL
<FILLING xxxx g>
VACUUM 20 min
OIL 30 CC
<FILLING xxxx g
>
8Æ5Æ 0Æ ENTERÆ
Open high and low
pressure, then
press START.
To Next Page
Loading...
Need help?
General