Launch Value-200 - Operator and System Data Configuration; Data and Time Setting

INSTRUCTIONS MANUAL
-28-
OPERATOR CODE:
Switch the machine on. The MAIN MENU will appear after a few seconds:
Select NEXT MENU:
Select DATA AND CONFIGURAT.:
Select CONFIGURATION:
Select INSERT OPERATOR NO.
It is now possible to input an alphanumeric code (up to 10 characters) that indicates the
number of the operator. This number will appear into all the printouts.
ENABLING TRACER FLUID INJECTION
The optional tracing mechanism may be installed on request on the machine . Follow the
procedure outlined below to enable the option.
Select OPTION from the CONFIGURATION MENU and press ENTER. Type in the code for
enabling tracing. Press key 1 to enable or key 0 to disenable. Press START. After enabling the
tracer, repeat calibration of the oil scale.
DATA AND TIME
The machine holds date and time data in memory for about one year, even if switched off.
Select NEXT MENU, DATA AND CONFIGURAT., CONFIGURATION, and then SET DATE &
TIME. The following screen will be displayed:
Press START to reset the date and time.
hh:mm:ss gg/mm/aa
ENTER CONFIRM
START MODIFY
DATA
CONFIGURATION
SERVICES
PREVIOUS MENU
LANGUAGE
MEASURE UNITS
OPTION
SET DATA & TIME
INSERT OPERATOR N.
AUTOMATIC PROCEDURE
ASSISTED PROCEDURE
NEXT MENU
GAS AVAIL XXXX G
CALIBRATION
DATA AND CONFIGURAT.
SERVICE ALARM
BOTTLE FILLING