Launch X-PROG 3 - Engine Programming

18
LAUNCH
X-PROG 3 User Manual
h. Touch
OK
.
• 3.2.3 Engine Programming
The engine programming function supports engine data reading, after a new
gearbox is replaced, you can use engine programming function to write in the
backup data.
• Connecting diagnostic system for Engine programming
Note:
• The USB cable shown in below diagram is not included in the packing
list for now, using a USB cable could effectively enhance your data
transmission speed.
• Vehicle engine connection could vary depending on engine types,
for information how to connect the car engine, refer to the onscreen
connection diagram.
• Operating on Engine Programming
Below procedure shows you how to perform engine programming for a
Volkswagen using Launch diagnostic product, the procedure contains chip ID