Launch X-PROG 3 User Manual

I
LAUNCH
X-PROG 3 User Manual
Copyright
Copyright © 2021 by LAUNCH TECH CO., LTD. All rights reserved. No part of
this publication may be reproduced, stored, or transmitted in any form without
the written permission of the copyright owner.
Trademark
Launch is a registered trademark of LAUNCH TECH CO., LTD in China and
other countries. All other marks are trademarks or registered trademarks of
their respective owners.
Disclaimer
The contents of this document are subject to changes without notice due to
continued improvements in design, manufacture, and methodologies. Launch
is not liable for the damage or losses due to the use of this document.
FCC Statement
Any Changes or modications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
a. This device may not cause harmful interference
b. This device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.

Launch X-PROG 3 Specifications

General

Brand	Launch
Model	X-PROG 3
Category	Car Alarm
Language	English

Summary

FCC Statement and Safety

FCC Statement

Details FCC compliance rules and conditions for operation of the device.

Safety Grades

Defines hazard levels: Danger, Warning, and Caution for user safety.

Safety Precautions

Lists essential safety rules to follow during operation and handling of the equipment.

Product Information

Packing List

Lists all included accessories and components that come with the main unit.

About this Manual

Target Reader

Identifies the intended audience for the user manual.

Typographic Conventions

Explains formatting elements used in the document for clarity and understanding.

Symbols Used

Defines the meaning of icons and symbols used throughout the manual.

About X-PROG 3

Product Overview

Provides a visual and descriptive introduction to the X-PROG 3 device.

Technical Specifications

Lists the key technical parameters and performance characteristics of the device.

Power Source

Details the methods available to power the X-PROG 3 device.

Accessories

Lists and describes all the accessories included with the X-PROG 3.

Diagnostics

Common Operations

Covers fundamental procedures for using the diagnostic functions.

Establish Hardware Connection

Guides on how to physically connect the device for diagnostic tasks.

Establish Wireless Connection

Explains the steps for setting up a wireless connection to the device.

Key Programming

Details the process of programming vehicle keys using the device.

Gearbox Programming

Provides instructions for programming vehicle gearboxes.

Engine Programming

Outlines the procedures for engine programming and data management.

Restore EEPROM Data

Software Upgrade

Warranty and Support

Warranty Information

Details the product warranty terms, coverage, and exclusions.

Customer Service

Provides contact information for technical support and inquiries.