LAVAZZA LB 951 - Pre-Dosed Button Dose Setting; Customizing Coffee Supply Amounts; Common Problems and Solutions; Troubleshooting Guide

SETTING THE PRE-DOSED SUPPLY BUTTON DOSES
EN
TECHNICAL FEATURES
Problem Possible causes Solution
The machine does not turn on.
» The machine is not connected to
the electric power supply.
» Check to see that it is plugged in.
The machine produces water rather
than coffee.
» The capsule loader lever is up. » Put the capsule loader lever in the
down position.
The machine takes a long time to
heat up.
» The machine has a lot of calcium
deposits.
» Decalcify the machine.
The pump is very noisy.
» There is no water in the tank. » Fill up with fresh drinking water.
The machine will not supply the
product and the button will blink.
» There is no water in the tank. » Fill up with fresh drinking water.
The capsule loader lever will not
close.
» Used capsule drawer is full.
» Capsule not inserted properly.
» Empty the used capsule drawer.
» Raise the capsule loader lever and
insert the capsule correctly.
The coffee gushes out too quickly
and the espresso cream does not
form.
» The capsule has already been
used.
» Insert a new capsule.
The three coffee supply buttons will
blink simultaneously.
» Water heating system damaged. » Bring the machine to an author-
ized service centre.
• Voltage: 220-240V 50/60 Hz
• Total wattage: 1200 W
• Power absorption (stand-by mode): , 0,5 W
• Tank capacity: 1,7 l
• Dimensions: H 280 mm L 200 mm P 320 mm
2006/42 CE - 2004/108 CE - 2006/95 CE
1
Press down the supply button to be modified for at least 3 seconds: the machine will notify a signal, i.e. the
LED will blink (1 second ON, then 1 second OFF).
2
Release the button (the coffee supply will start).
3
Once the desired amount of coffee has been obtained, stop supply by pressing the same button.
• The minimum dose that can be set is 20 cc.
• If the programming does not end within 110 seconds, the supply will be stopped automatically. The
machine will notify a signal, i.e. the LED will blink (1 second ON, then 1 second OFF) and the last dose
previously set will be stored into the memory.
• To resume the factory-set values for the set doses, simultaneously press down the two pre-dosed supply
buttons for 5 seconds.
SOLUTIONS TO THE MOST COMMON PROBLEMS
• Weight: 4,6 kg
• Collector drawer: 10 capsules
• Material used in the body
(accessible parts generally): ABS + PC