16
This log splitter is equipped with a
reinforced splitting wedge and has a
blade which is specially treated. After
long periods of operation, and when
required; sharpen the wedge using a
fine-toothed file removing any burrs or
flat spots on the edge.
SHARPENING WEDGE
Read dipstick to determine
the maximum and minimum
of the oil level. Low oil
can damage the oil pump.
Overfilling can result in
excessive temperature in
the hydraulic transmission
system.
TROUBLE SHOOTING
ATTENTION: ALL REPAIR WORK MUST BE DONE BY A SPECIALIST
FOR THIS PRODUCT.
PROBLEM PROBABLE CAUSE REMEDY SUGGESTED
Motor does not
start
No current in the socket Check mains fuse
Electrical extension line
defective
Unplug, Check and replace.
Incorrect connection line
3~400V
5-line connection at 1.5mm
diameter
Switch defective Have checked by Electrician
Incorrect motor
rotation direction
Incorrect connection
Change pole switching
device in the plug with a
screw driver
Reverse polarity by
electrician
Log Splitter does
not work while
motor running
Valve is not opened owing
to the connection parts
loosening
Check and tighten the parts.
Control Levers or Connection
parts bent
Repair the bent parts
Lower hydraulic oil level Check and refill hydraulic oil.
Log Splitter
works with
abnormal
vibration and
noise
Lower hydraulic oil level Check and refill hydraulic oil.
* The shaded part is only used for the model #65886.
To Next Page
Loading...