7
UNPACKING
At least 2 people are required to
unpack the log splitter package. Take
the following steps to put the Log
Splitter on the ground by tipping every
side of the carton by 45 degree. Make
sure put Block (B) to support the Log
Splitter package (A) at the point a
little higher than the middle. The other
side of Block (B) should be against a
steady object, such as a wall. Wedge
(C) should be arranged under the
tipped Log Splitter Package (A) every
step to avoid slipping. Then remove
the carton off the Log Splitter.
A
B
C
A
B
C
A
B
C
A
B
C
A
180°
90°
180°
A
1 2
3
4
5
APPLICATION CONDITIONS
This log splitter is designed for operating
under ambient temperatures between +5°C
and 40°C and for installation at altitudes no
more than 1000m above M.S.L. The surrounding
humidity should be less than 50% at 40°C. It
can be stored or transported under ambient
temperatures between -25°C and 55°C.
For model #65887, #65887(A):
With 230 Volt / 50Hz motor, the log splitter
should be connected to standard 230V
±
10%
/50Hz
±
1%.
Electrical supply which has protection devices
of under-voltage, over-voltage, over-current (16
A) as well as a residual current device (RCD)
which maximum residual current ratedat 0.03A.
Electrical connection rubber cables must comply
with EN60245 which are always marked with
symbol H 07 RN. Cables should be identified, as
it is a legal requirement.
ELECTRICAL REQUIREMENTS
For model #65886:
With 3 phase 400 Volt / 50Hz motor, the
log splitter should be connected to standard
400V
±
10% / 50Hz
±
1%.
Electrical supply which has protection devices
of under-voltage, over-voltage, over-current as
well as a residual current device (RCD) which
maximum residual current rated at 0.03A. The
mains connection and extension cable must
have 5 wires = 3P + PE (3/PE). The mains
connection must have maximum 16 A fuse.
Electrical connection rubber cables must comply
with EN60245 which are always marked with
symbol H 07 RN. Cables should be identified, as
it is a legal requirement.
To Next Page
Loading...