To Next Page

To Previous Page

NOTE: Always clean the main spool cover and trimmer head housing before reassembling the trimmer

head.

NOTE: Always clean the trimmer head before replacing the spool.

■ Check the spool cover, spool and trimmer head housing for wear and replace parts if necessary.

Install the spool in the spool cover and replace as described in the Spool Replacement section.

NOTE: Only use the appropriate cutting line specied in this manual.

TRIMMER HEAD REPLACEMENT (See Fig. 44)

■ Stop the engine and remove the battery pack.

■ Place the trimmer on a at stable surface with the trimmer head facing upward.

■ Insert the provided hex wrench into the hole on the ange to lock the spindle. Then rotate the

trimmer head clockwise to remove (Fig. 44).

■ To install the new trimmer head, hold the hex wrench to lock the spindle. Then rotate the trimmer

head counter-clockwise to install. Make sure the trimmer head is installed tightly.

■ Remove the hex wrench from the hole.

MAINTENANCE

■ Place the ends of the line in the two opposite parking slots of the spool, leaving some of the line out

(Fig. 43).

Winding Direction

Fig. 42

Fig. 43

Fig. 44

LawnMaster NPTGSP2517A User Manual

Other manuals for LawnMaster NPTGSP2517A