35
MAINTENANCE
* NOTICE: THE USE OF EMISSION CONTROL COMPONENTS OTHER THAN THOSE DESIGNED
FOR THIS UNIT IS A VIOLATION OF FEDERAL LAW.
STORAGE
Clean the trimmer of any debris and store indoors in a dry, well-ventilated area that is inaccessible to
children. Keep away from corrosive agents such as garden chemicals and de-icing salts.
Abide by all ISO and local regulations for the safe storage and handling of gasoline.
Storing for 30 days or longer:
Drain all the fuel from the tank into a container approved for storing gasoline. Press the primer bulb 3 - 4
times to remove the remaining fuel from the carburetor. Run the engine until it stops.
HIGH ALTITUDE ENGINE OPERATION
Initially your engine is congured for operation below 2000 ft. altitude. If the trimmer is being used
above 2000 ft. altitude, the engine must be re-congured accordingly. Operating the engine with the
wrong engine conguration at a given altitude may increase its emissions, drop fuel efciency, reduce
performance and cause irreparable damage. Engines congured for high altitude operation will need to
be recongured for use in standard altitude conditions. Your authorized service center should ensure that
your engine is properly congured for your location.
THIS PRODUCT WAS MANUFACTURED WITH A CATALYST MUFFLER
Congratulations! You have made an investment toward protecting the environment. In order to maintain
this product’s original emission level, please refer to the maintenance section below.
MAINTENANCE SCHEDULE
* CATALYTIC MUFFLER ASSEMBLY
SPARK SCREEN
* AIR FILTER ASSEMBLY
Includes: Filter Screen
* CARBURETOR ASSEMBLY
Includes: Gaskets
Y
Y
Y
Y
Y
Y
Y
* FUEL TANK ASSEMBLY
Includes: Fuel Lines & Fuel Tank Cap
Fuel Filter
* IGNITION ASSEMBLY
Includes: Spark Plug
Maintenance Part
Inspect For
Damage
Before
Each Use
Clean
Every
5 Hours
Replace
Every
25 Hours
or Yearly
Replace
Every
50 Hours
To Next Page
Loading...
Need help?
General
