Created for Smart Laziness
PROVIDE INTERNET ACCESS TO A WIRED DEVICE
USE REPEATER IN THE AP MODE
USING ETHERNET CONNECTION
To enable wired internet connection to other
devices, first set up Internet access on the
repeater using method 1 or 2. Once your repeater
has Internet connection (the Signal LED is solid
blue), plug the ethernet cable to the bottom of
the repeater and to another device.
You can use your ethernet cable to enable
Internet connection to wired devices like gaming
consoles, cameras, PC, etc.
If you want to use the repeater
in the Acess Point (AP) mode, follow the steps below:
1. Plug the repeater into a power outlet near your modem/router. Wait until
the PWR LED turns solid blue.
To Next Page
Loading...
Need help?
General