Rev:072409 Copyright © 2009 Liquid Combustion Technology, LLC LCT Engine Service Manual: 208cc, 291cc & 414cc 10
Engine Oil Level Check
Check the engine oil level with the engine stopped and with the engine in a level position.
1. Remove either side mounted ller cap dipstick or high oil ll dipstick and wipe it clean.
2. Insert and remove the dipstick without screwing it into the ller neck. Check the oil level shown on the dipstick.
3. Iftheoillevelislow,lltotheedgeoftheoilllerholewiththerecommendedoil.
4. Securely screw in the ller cap/dipstick. Running the engine with a low oil level can cause engine damage.
Always check the engine oil before start up.
Engine Oil Change
Draintheusedoilwhiletheengineiswarm.Warmoildrainsquicklyandcompletely.
Avoid contact with hot oil.
1. Place a suitable container below the engine to catch the used oil then remove the
ller cap/dipstick and the drain plug.
2. Allowtheusedoiltodraincompletely,thenreinstallthedrainplug,andtighten
it securely. Do not over tighten. Dispose of used motor oil in a manner that is
compatiblewiththeenvironment.Wesuggestyoutakeusedoilinasealed
container to your local recycling center or service station for reclamation. Do not
throwusedoilinthetrash,pouritontheground,orpourdownadrain.
3. Withtheengineinalevelposition,lltotheouteredgeoftheoilllerholewiththe
recommended oil. (see ll limits right)
• NOTICE
Running the engine with a low oil level can cause engine damage.
4. Securely screw in the ller cap/dipstick.
Engine Oil
Recommendations
Engine oil affects performance and service life. Use 4-stroke automotive
detergent oil.
SAE10W-30isrecommendedforgeneraluse.Otherviscositiesshownin
the chart may be used when the average temperature in your area warrants.
The SAE oil viscosity and service classication are in the API label on the oil
container. The manufacturer recommends you use API SERVICE category
SJengineoil,orbetter.
Fillifoilis
belowletter
“L”onthe
llercap
Fillifoil
isbelow
“Add”
onthe
dipstick
Max Upper
Level
Max Lower
Level