LS600 Installation and Operation Guide 4
www.leadsolarenergy.com
Notes
1.1 Validity
This installation manual describes the assembly, installation, commissioning, and maintenance and failure
identification of the following inverters:
LeadSolar LS600
1.2 Symbols used
The following symbols are used in this manual:
WARNING!
This indicates a safety hazard that could cause personal injury or equipment
malfunction. Follow these instructions carefully to avoid or reduce the risk.
NOTE
This indicates important information that is critical to optimizing system
performance.
1.3 Safety Instructions
1. Follow local installation codes. Make sure to adhere to all applicable national and local
electrical codes during installation. Only qualified personnel should install or replace LeadSolar
Microinverters.
2. No DIY repairs. Users must never attempt to repair or modify the LeadSolar Microinverter
themselves. If the microinverter fails to operate, contact LeadSolar customer service for repair or
replacement. Tampering with or opening the hardware will void the warranty.
3. Read the instructions. Read all instructions and cautionary notes before installing or using
LeadSolar hardware.
4. Disconnect safely. Disconnect the AC power grid connection first before disconnecting the PV
module from the LeadSolar Microinverter.
5. Microinverter can get hot. The majority of the LeadSolar Microinverter is a heat sink. Under
normal operating conditions, the temperature is 59°F (15°C), but in can reach 176°F (80°C) under
extreme conditions. To reduce risk of burns, use caution when working with microinverters.
6. It’s already fine-tuned for your region. Be aware that the LS600 have different default factory
settings for the applications in different regions throughout the world. The LS600 do not need field
adjustment or tuning. It will start to deliver power to the electric grid automatically after installation.
To Next Page
Loading...