EasyManua.ls Logo

LeapFrog MAGIC ADVENTURES BINOCULARS - Care and Maintenance

LeapFrog MAGIC ADVENTURES BINOCULARS
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
CARE & MAINTENANCE
1. Do not point the binoculars directly at the sun and never leave the
unit where direct sunlight can enter either the Binoculars Objective
or Ocular Lens. Light ray concentration can damage the device
and cause the binoculars to stop working. It can also cause fires
and/or burns.
2. Keep the unit clean by wiping it with a slightly damp cloth.
3. Keep the unit out of direct sunlight and away from any direct heat
sources.
4. Remove the batteries if the unit will not be in use for an extended
period of time.
5. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
6. Avoid sharp impacts. Use the included Wrist Strap to avoid
accidently dropping the unit to prevent mis-alignment of the optics.
7. NEVER try to dismantle the unit.
Cleaning the Binoculars Objective or Ocular Lens
Blow away any dust or debris on the lens (or use a soft lens brush).
To remove fingerprints or other smears, clean with a soft, lint-free
cloth rubbing in a circular motion. A “microfiber” cleaning cloth
(available from camera or computer retailers) is ideal for the routine
cleaning of your optics.
For a more thorough cleaning, photographic lens tissue and
photographic-type lens cleaning fluid or isopropyl alcohol may be
used. Always apply the fluid to the cleaning cloth – never directly
on the lens.
Do not use excessive pressure - this may scratch the lens.
Cleaning the LCD Screen
Slightly dampen a soft, lint-free cloth with water and wipe the screen
to loosen dirt.
Using a clean and dry cloth, wipe the screen dry. Repeat these two
steps as needed.