Leb Electronics CTR44 - User Manual

1
MANUALE D’ISTRUZIONI
INSTRUCTIONS MANUAL
MANUEL D’EMPLOI
ITALIANO 3
ENGLISH 12
FRANCAIS 21
La casa costruttrice si riserva il diritto di apportare modifiche o miglioramenti al prodotto senza preavviso. Eventuali errori riscontrati nella presente
edizione saranno corretti nella prossima.
Man. V1.0 06-12-2004
The manufacturer reserves the right to modify or improve the product without prior notice. Any inaccuracies or errors found in this manual will be
corrected in the next edition.
Le constructeur se réserve le droit d’apporter des modifications ou des améliorations au produit sans aucun préavis. Les éventuelles imprécisions ou
erreurs trouvées dans cette édition seront corrigées dans la prochaine édition.

Leb Electronics CTR44 Specifications

General

Brand	Leb Electronics
Model	CTR44
Category	Controller
Language	English

Summary

Scope of the Device

Limits to Use and Safety Precautions

Installation Procedure

General Product Characteristics

Motor Work Time Control

Operation Modes Overview

Electrical and Mechanical Specifications

Electric Connections

Terminal Board J1 Connections

Details connections for motor and blinker on J1.

Connector J2 Details

Details for J2, including power regulator and mains supply connections.

Terminal Board J3 Aerial Connection

Describes aerial cable connections for J3.

Terminal Board J4 Low Voltage Connections

Details low voltage connections for J4, including safety devices and controls.

Terminal Board J5 Mains Power Cable

Describes mains power cable connections for J5.

Device Connection Summary

Maintenance Guidelines

Declaration of Conformity

Programming the Control Card

Step-by-Step Logic Programming

Configuration for step-by-step operation mode using jumpers.

Automatic Closing Logic Configuration

Configuration for automatic closing operation mode using jumpers.

Immediate Closing Logic Setup

Configuration for immediate closing operation mode using jumpers.

Photo-stop Logic Programming

Configuration for photo-stop safety logic using jumpers.

Remote Controls Code Learning

Procedure for self-learning remote control codes.

Erasing Stored Remote Codes

Procedure for erasing all learned remote control codes.

Setting the Pause Time

Procedure for programming the pause time duration.

Setting the Work Time

Procedure for programming the motor's work time.