Leckey BeMe - Page 79

Leckey BeMe User Manual p79
To attach the angled shoulder spacer,
remove the cushion cover from the shoulder
moulding and remove the four screws to
separate the moulding from the clamp
.
Place the back plate pacer
, onto the front
surface of the clamp moulding
.
SECTION 16.37:
ATTACHING AND
DETACHING
SHOULDER ANGLE
SPACER MODERATE
BACKREST ONLY
Secure the angled shoulder spacer using the
four longer screws
. Reattach the shoulder
moulding by tightening the screws
E
, into
the angled shoulder spacer.
The process should not be reversed using the
same hardware. To remove the spacer, a new
basic backrest clamp will be required.
E