8.1 Measurements and
Initial Set Up
8.2 Adjusting the
Seat Height
To set up the Kidwalk effectively the following
measurements should be taken and recorded:
1. Inside leg
2. Hip Width
3. Chest Width
4. Thoracic Height
5. Head Height (to eye level)
The thoracic height and head height should
be taken from the top of the inside leg.
These dimensions are needed to set up
the Lateral chest system and the various
headrests available.
Using the lift/release handle (A) or the
fine tune adjustment handle (B) adjust the
seat height to 1” lower than the inside leg
measurement. The height can then be fine
tuned with the child in the seat.
To raise the seat assembly with the lift/release
handle (A) press down on the top of the mast
while lifting up on the lift/release handle.
To raise the seat assembly using the fine
adjustment, place your hand in the handle
and squeeze the lower fine tune handle (B).
Each time you squeeze the fine tune handle,
the seat will rise up ½”.
To lower the seat assembly simply press
slightly downward on the lift release handle.
Minimal pressure is required to slide
the seat down the mast. Do not push
too hard. Removing downward pressure
from the lift release handle will stop the
seat from lowering.
B
A
To Next Page
Loading...
