Lee Precision PRO 1000 - Shell Plate Carrier Installation; Carrier to Ram Attachment

SHELL PLATE PARTS LIST
When changing calibers that use a dierent primer
size, we recommend changing the entire shell plate
carrier. If caliber uses the same primer size, you
can easily change just the shell plate.
TR21391/4 –20x1⁄ Bolt
FO1770 #8 - 32 x ¼” Screw
FT1781 #8-32 x ¼” Screw
TR2439 Gear Plate
TR2433 Detent Ball
TR3742 Index Spring
TR2431 Drive Bolt
TR2550 Sensor Bushing
FT1940 Sensor Screw
TR2548 Case Sensor
TR2435 ¼ x 20 x ¾ Socket Head Screw
90108 Hex Ratchets (1 installed, 2 spares)
TR2432 Ratchet Gear
TR2443
Tension Fingers
(2 installed, 2 spares)
TR3975 Carrier
TR2164B Primer Trough, Large
TR2164C Primer Trough, Small
90606 Folding Primer Tray (2-pack)
TR2436 Primer Pin, Large
TR2437 Primer Pin, Small
TR2479 Primer Spring
TR2442 Case Ejector Pin
(1 installed; 1 spare)
7
INSTALLING THE SHELL PLATE CARRIER
The carrier is attached to the ram with a single socket head screw. This makes it very easy to change the entire carrier for caliber changing.
A
B
C
TIGHTEN
Re-install turret with dies and raise your
carrier to completely seat it on to the
ram. Tighten the carrier socket head
screw with a 3/16” hex wrench.
Be sure to keep the primer trough pin
behind the right rear column. Push the
assembly onto the ram’s end.
Push the action rod through the carrier from
the bottom side until the end slightly protrudes
through the top. Be sure the twisted end is
down.
TR2549 Sensor clip
TR2437 Primer pin, small
TR2436 Primer pin, large
short end gets installed down