11
4.1 START UP AND TURN OFF UPS
1. Turn on the UPS in Line mode
Once AC Power Cord is plugged in, the UPS will start automatically, and the LCD
display of the UPS will be lit on. You may view the data and set parameters on the
LCD display as well as the LED display showing the status of the UPS.
2. Turn on the UPS in Battery Mode
Press “On” on the front panel to start the UPS and in the meantime, the LCD
display will light up. You may view the data and set parameters on the LCD
display and the LED display of the UPS will show the latest status of the UPS.
ώ Before installing battery, make sure that the UPS and breaker are all turned off.
Remove all your metallic adornment such as finger ring, watch, and so on before
connecting battery.
ώ No anti-connection or short circuit between the battery anode and cathode fore-
ver. Red cable connects to battery anode “+” and black cable connects to cathode
“-”.
ώ Please use the screwdriver with insulating handle. Do not lay the tools or metallic
goods on the battery.
ώ When using the external battery, it is best to use external battery cable which
matches with the equipment.
ώ When connecting load to UPS, first turn off load and then connect the power cable
and finally turn on load one-by-one.
ώ Inductance loads such as motor, fluorescent lamp and photocopier are strictly
prohibited connecting to UPS to avoid damage.
ώ Plug UPS on the special socket with over-current protection, the power socket
that used should be connected to ground wire.
ώ UPS is likely to have output voltage no matter whether the power input cable is
plugged in mains input socket. If you wish UPS have no output, first break off the
switch and then cancel the mains.
ώ When connect laser printer, select the capacity of UPS according to the UPS start
power because the startup power is higher.
WARNING:
4.1.1 Start up operation
NOTICE:
4. Panel display, operation and running
The operation is simple, operators only need to read the manual and follow the operation
instructions listed in this manual, no need any special training.
To Next Page
Loading...
