installation
1 | Plug unit into 120 VAC power socket protected by fuse or circuit breaker.
2 | With no load connected the unit will automatically become energized and
the indicator will blink green and amber after 10 seconds.
3 | Press “Test/Off” button.
4 | Verify the lamp indicator changes to blink white and amber
(this step denotes that power is off).
5 | Press and release “Reset/On” button for use.
6 | Connect the desired load equipment to cord receptacle and operate
equipment normally.
NOTE: All three plugs are controlled together.
To Next Page
Loading...
