Leibinger Jet 3 - Page 114

Group 7 Data/Programming Page 112
Release R2.0 LEIBINGER JET3
Printstyle (5)
<Print height>
Default (80%)
<Orientation>
Default (0°)
<mirrored>
Default (no)
Print Parameter (6)
<PrintGo Distance>
Not available for <Batch Job>. Parameters
defined within a print job will be ignored.
<PrintGo Repeat>
Not available for <Batch Job> job list. Para-
meters defined within a print job will be ignored.
<endless>
Not available for <Batch Job> job list. Para-
meters defined within a print job will be ignored.
<PrintGo Source>
<Extern> and <positive edge>.
<PrintStop interrupts print-
out immediately>
Default (no)
<PrintGo Gate>
Default (no)
Encoder Parameter (7)
<Encoder Source>
Extern
<Resolution>
12.500
<intern Speed>
Not available if an external encoder is used
<Encoder/Direction>
Clockwise
<Speed dependent output>
Not used. Default (700)
<lock backward>
yes
Date Change Parameter (8)
<Date Change Offset>
Default (0)
7. Save the created job list (9-12).
8. Open the job list with the <Load Joblist to print> command (13-14).
9. Get the printer ready to print (open nozzle seal, push green <PrintStart>
button).
10. With the next <PrintGo> signal the first print job of the job list will be printed.
There are no repetitions defined for this print job, therefore there will be only
one print out. The <PrintGo delay>is 0 mm (13).
11. With the next <PrintGo>signal the second print job of the job list will be
printed. There are two repetitions defined, therefore there will be two more
print outs with the next two PrintGo signals. The <PrintGo delay> for each
printed job is 20 mm (13).
12. With the next <PrintGo> signal the third print job of the job list will be
printed. There is one repetition defined, therefore there will be one more print
out with the next PrintGo signal. The <PrintGo delay> for each printed job
is 30 mm (13).
13. With the next <PrintGo> signal the fourth print job of the job list will be
printed. There are three repetitions defined, therefore there will be four more
print outs with the next four PrintGo signals. The <PrintGo delay> for each
printed job is 20 mm (13).