Leibinger Jet 3 - Job Organisator List Creation (Example 4)

Group 7 Data/Programming Page 113
Release R2.0 LEIBINGER JET3
14. With the next <PrintGo> signal the fifth print job of the job list will be
printed. There no repetitions defined, therefore there will be a total of one
print out. The <PrintGo delay> for each printed job is 30 mm (13).
15. The task is finished.
Basic rules for the job list type <Batch Job>:
 Each print job is managed separately.
 A <PrintGo> signal is required for each print out and each repetition.
 If a single print job of the job list has to be edited, this has to be carried out
with the job editor. The print job on the list has then to be exchanged against
the revised print job. It is not possible to edit a job on the job list directly.
 <PrintGo distance>, <PrintGo repetition> and the option for <endless>
print out are not available for <Batch Job> job lists. All settings regarding
these parameters which were made within the print jobs will be ignored.
 A <PrintGo delay> can be defined within each print job separately.
 The WYSIWYG preview of the main window always shows the print job that
will be printed with the next <PrintGo> signal (14).