Leibinger Jet 3 - Accessing Settings Menus

Group 7 Data/Programming Page 118
Release R2.0 LEIBINGER JET3
Basic rules for the job list type <Job Organisator>:
 The print out of the complete job list including all repetitions is started with
one <PrintGo> signal.
 If a single print job of the job list has to be edited, this has to be carried out
with the job editor. The print job on the list has then to be exchanged against
the revised print job. It is not possible to edit a job on the job list directly.
 All distances assigned to print jobs on the job list are related to the same
reference point. The reference point is set with the <PrintGo> signal.
 If a distance assigned to a job is shorter than the sum of all distances and
print jobs lengths coming before that job no error message occurs. The too
short distance will just be ignored and the print out will start right after the
last print job. Too short distances between the print jobs on the job list, too
short distances for print jobs will lead to wrong distances for defined print job
repetitions!
 For the <PrintGo distance> which is defining the print out distance for
repetitions the same reference point is used as for the distances assigned to
the print jobs on the joblist. For each additional repetition the <PrintGo
distance> is added up respectively. Here also all defined distances will be
considered.
 If the <PrintGo distance> of the job list is shorter than one complete print
out of the job list no error message occurs. The too short distance will just be
ignored and the print out of the repetition will start right after the last print
out.
 The WYSIWYG preview of the main window always shows the print job that
will be printed with the next <PrintGo> signal (14).