Leibinger Jet 3 - Page 119

Group 7 Data/Programming Page 117
Release R2.0 LEIBINGER JET3
Printstyle (5)
<Print height>
Default (80%)
<Orientation>
Default (0°)
<mirrored>
Default (no)
Print Parameter (6)
<PrintGo Distance>
150 mm
<PrintGo Repeat>
1
<endless>
Not selected
<PrintGo Source>
<Extern> and <positive edge>.
<PrintStop interrupts print-
out immediately>
Default (no)
<PrintGo Gate>
Default (no)
Encoder Parameter (7)
<Encoder Source>
Extern
<Resolution>
12.500
<intern Speed>
Not available if an external encoder is used
<Encoder/Direction>
Clockwise
<Speed dependent output>
Not used. Default (700)
<lock backward>
yes
Date Change Parameter (8)
<Date Change Offset>
Default (0)
7. Save the created job list (9-10).
8. Open the job list with the <Load Joblist to print> command (11-12).
9. Get the printer ready to print (open nozzle seal, push green <PrintStart>
button).
10. The <PrintGo> signal sets the reference point for all distances assigned to
the print jobs on the job list. The first print job of the job list will be printed in
a distance of 30 mm to that reference point (13).
11. The second print job of the job list will be printed in a distance of 70 mm to
the reference point (13).
12. The third print job of the job list will be printed in a distance of 110 mm to
the reference point. (13).
13. In the <PrintGo Parameters> of the <Joblist Settings> parameter for
<PrintGo distance> and <PrintGo repetition> were set. The <PrintGo
distance> was set to 150 mm and there shall be one repetition. Therefore all
three jobs on job list will be printed again in the same matter as described in
points 9-11. The repetition will start 150 mm from the reference point (13).
14. The task is finished.