Leibinger Jet 3 - Factory Settings Reset

Group 7 Data/Programming Page 130
Release R2.0 LEIBINGER JET3
Proceeding:
 Press on the tab <Interval> (2) to select the tab.
 Now mark in the setting field <Interval On> (3) the hour- or minute block to
change the values.
 With the the two <Arrow keys> (6) you can increase or reduce the blocks wich
are each marked.
 Now carry out the settings in the field <Interval Off> (4) accordingly.
 Now activate if necessary the viscosity control by clicking on the checkbox (7).
An activated control is displayed by a  in the checkbox.
7.3.1.4 Interface (Encoder interface)
Under the tab < Interfaces> you can set the interface for the incremental encoder
and you can also switch on or off the bounce time delay. The bounce time delay is
required for working with external jobs.
How can you explain the terms „bounce time“ and „bounce time delay“?
Bounce time: Describes the period which a signal requires after an input has been
switched to reach a defined status (0 or 1) again.
Bounce time delay: Describes a predefined safety time. That means if an input is
switched, the signal will be only valid after this safety time.
At the LEIBINGER JET3 you can switch on or off this safety time.
Bounce time delay
Advantages
Disadvantages
off
Faster change of jobs
No safety for bouncing signals
afterwards
on
High safety for bouncing
signals afterwards
Slower change of jobs
Figure 53
Time (t)
defined
status
t
Safety
(disengageable)
Switching of
inputs
Input- Signal gauge )